CAI-QMINP-01 - QMini Plug Connector Customer Assembly Instructions
Document:
CAI-QMINP-01
Revision:
14
Release Date:
12/08/2014
Revision Date:
10/14/2019
QPC Fiber Optic, LLC
www.qpcfiber.com
27612 El Lazo Road, Laguna Niguel, CA 92677
Ph: (949) 361-8855
Page 8 of 9
FINAL ASSEMBLY
Use the Hex Driver PT-504 to align the key and install the insert into the back of the Body. The Insert
should protrude slightly from the seal and the Body. The seal should be visible around the Insert.
Slide the Wave Spring and Strain Relief into place. Place onto the QMini Torque Fixture PT-392. Hand
tighten the Strain Relief while on the Torque Fixture so that the fibers do not get twisted or kinked. Torque
the Strain Relief using the Adjustable Crowfoot Wrench PT-536 with the Dial Torque-Measuring Wrench
PT-506 to the values in the above Torque Table. Inspect the fibers by looking through the holes in the
Strain Relief making sure that the fibers are not twisted or kinked. Use Cable to pull Crimp to bottom of
Strain Relief. Use the Hex Driver PT-501 to tighten the set screws on the strain relief to lock the crimp into
place. Torque the Set Screws using Torque-Measuring Hex Drive PT-590 and Hex Bit 1/16-inch PT-599 to
the values in the above Torque Table.
Perform a final visual check by looking through the
holes of the Strain Relief to make sure that the fiber
is not twisted or kinked.
