PROGRAMMING:
To Install Batteries:
1)
Turn the base upside down and remove battery cover.
2)
Install 4 new “D” cells, alkaline batteries.
(Be sure to match positive and negative markings)
3)
Replace battery cover. Be sure to snap in place.
To Turn Unit ON:
1)
Press the (-) side of the on/off switch
DOWN
. (Located on
the bottom of the base)
2)
Set unit right side up. (LCD screen should be facing you)
To Set the feeder at Running Mode or Sleep Mode
1)
Press “Select” until the
(Running Model) is flashing. Use up and down to change the value to
(Sleep Mode). Press “Save” when finish.
2)
In
mode the feeder will operate as schedule. In
mode the feeder will not operate.
To Set Current Time:
1)
Press “Select” until “Hours” is flashing in the current time box.
2)
Press the “up” or “down” buttons to configure the current hour.
3)
Press “Select” again to configure minutes of the day. Press the “up” or “down” buttons to adjust
minutes to current time.
4)
Press “Save” when finished
To Program Days Served:
1)
Press “Select” button to cycle through options until “Every Day” is seen flashing on display.
2)
Press the “Up/Down” button to the desired amount of feeding days (Set 1-99 Days or Everyday)
3)
Press “Save” to confirm.
To Program Feeding Times With Portions:
1)
Press “Select” until the top box under the feeding times section is flashing
2)
Press “Up” or “Down” to adjust feeding time accordingly. (NOTE: Feeding times are set to half
hour increments)
3)
Press “Select” to move onto the feeding portion box when finished programming the first feeding
time. (NOTE: The number of CUPS served will be flashing)
4)
Using the “Up” or “Down” button to program the desired portion to be served. (Portions are in ¼
cup increments and max out to 5 cups total)
5)
Repeat steps 1-4 to complete feeding other times with portions.
6)
Press “Save” to confirm.
To Set a Manual Feeding:
1)
Press and hold the “Save” and “Down” button at the same time until the Manual Feeding box and
the portion box flashing.
2)
You can then use “Up” and “Down” button to adjust the portion you desire to serve.
3)
Press “Save” button to start the manual feeding.
To Record and Play message:
1)
Press and hold “Play” button for 5 seconds until the countdown timer displays in the current
time box.
