7.
Press
1/2 Button
to switch to
Channel 1
, and then press
MODE Button
to switch
to
Vibration Mode
( icon will show on the LCD display).
8.
Press
Up/Down Button
to select a vibration level, and then press
Y Button
, the
receiver will vibrate.
9.
For SP 209
, press
1/2 Button
to switch to
Channel 2
, and then press
MODE
Button
to switch to
Vibration Mode
( icon will show on the LCD display).
10.
Press
Up/Down Button
to select a vibration level, and then press
Y Button
, the
receiver will vibrate.
NOTE:
Please always install the transmitter’s battery BEFORE install the Re batteries
of receivers. As it is a wireless training system, the transmitter has to be power
on then the receiver will be able to receive the code from transmitter.
Step 3: Install the Electrodes for Receivers
Randomly pick on pair of electrodes and screw them on receivers. (Please pick the same
size electrodes for each receiver)
Step 4: Adjust the collar to fit your pet
To ensure a proper fit, please follow the steps below:
1.
Put the straps on the receiver.
2.
With your dog
standing
, centre the collar receiver where contact points are
underneath your pet’s neck, touching the skin.
3.
The collar receiver should fit snugly, yet loose enough to allow on finger to fit
between the strap and your dog’s neck. If the strap is too long for your dog, cut
off the excess length.
4.
Allow your dog to wear the collar for several minutes and then recheck the fit.
Check the fit again as your dog becomes more comfortable wearing the collar
receiver.
We would recommend you to use the Tone Function before starting static
shock and always start with the lowest level of static shock.
4
