QPS Que! USB 2/1.1, Quick Install Manual

USB 1.1 Insta l l at i o n

NOTE:  Please be sure that your on-board USB 1.1 port is installed correctly and
functioning properly prior to connecting the Que! USB 2 / 1.1 CD-RW drive. Please
remember that when connecting to the on-board USB port, your Que! USB 2 / 1.1
CD-RW drive will only be capable of speeds up to 4x max.

Before you plug in your new Que! USB 2 / 1.1 CD-RW drive, you must run the
"TPPINST.EXE" driver file installer. This file is located in the "Drivers" folder on your install
CD that was in your kit. After installing the drivers, restart the system and plug in your
new Que! USB 2 / 1.1 CD-RW drive.

Step 1. Plug the power adapter into the wall receptacle and into the back of the drive.

Step 2. Plug the USB cable into the on-board USB 1.1 port on the back of your computer 

system then into the port on the back of the drive.

Step 3.  Let Windows detect your new Que! USB 2 / 1.1 CD-RW drive. 

Step 4. Reboot your computer, this will only be necessary the first time you install 

the drive.

Step 5.  Verify that your new Que! USB 2 / 1.1 CD-RW drive is available for use within the

Windows operating system.

Step 6.  Install the CD-Recording software that is supplied on your Install CD.

Note: Please refer to the Que!  USB 2 / 1.1 Installation Manual, located on your Installation disc.

8

USB 1.1 INSTA L L AT I O N