Part 3. Installing the UDF Reader
Step 1.
Select UDF Reader. When you do this “Adaptec Setup
Wizard dialogue box will pop-up and display the follwing
questions:
“This Setup wizard installs the Adaptec Direct CD (UDF) Reader for
window 95/ Window NT. Do you wish to continue?”
Set 2.
Select “Yes” to install the UDF raeder software
Set 3.
At the next screen choose the language you prefer and then
choose the “Next>” button
Set 4.
Now click on the “Install” button to load the software
Set 5.
Then click on “Exit” at the “Master Setup” window
Set 6.
The “Setup Complete” window pops up and asks if you wish
to restart your system now; the default is yes
Set 7.
Choose the “Finish” button to exit the setup wizard
Part 4. Installing the USB drivers
Step 1. Power up your PC and verify that the system has booted up
and the Windows Operating System Desktop is loaded.
Step 2. Switch the power on at the rear of the Que! USB Drive. When
you do this the operating system should detect the Que! USB
Drive and start the “Add New Hardware Wizard”.
Step 3. Insert the Que! installation CD in your system’s CD-ROM drive.
Step 4. Immediately after you power on your Que! USB Drive
Windows 98 will display the “New Hardware Found” window
and then automatically display the “Add New Hardware
Wizard” window.
Step 5. Press the “Next>” button.
23
PC Installation
Summary of Contents for Que!
