CLI Command Sets
9
CLI >
help
------------------------------------------------------------------------------
Command Description
------------------------------------------------------------------------------
buzzer Turn off system buzzer
clrlog Clear all event logs of the system
date Set the system time or show the system time
disk Show installed disk information (slot location, vendor, model)
evtlog Display event logs of the system
fan Show cooling fan information
fwdl Download firmware code for upgrade
help List all supported commands or usage of specific command
id Assign an enclosure ID for management use
ident Identify the system or a drive slot
logout Logout CLI mode
port Show the host port connection status and WWPN
psu Show power supply units status and information
reboot Reboot the system
rtdft Reset all setting to factory default
sensor Display system's sensors information
serv Change service port output
setpwd Change the password
shutdown Shutdown the system
sys Show the system's hardware and FW information
sysname Set or show the system name
temp Show the system's temperature information
volt Show the system's voltage information
zone Zoning display or set configuration
------------------------------------------------------------------------------
2.
Show the usage of the specific CLI command “help”.
CLI >help help
Command : help
Description : Display all supported commands or specific command's usage
Syntax : help [command]
Parameter Desc : Optional. Show the usage of the specific CLI command.
2.2.
General System Settings
This section includes the following command sets.
sysname
: Show or set the system name
date
: Show or set the system time
setpwd
: Change the password
Summary of Contents for XCubeDAS CubeView XD5324S
Page 12: ......
Page 15: ...Getting Started with CLI 3 ...
