XCubeFAS Series
Hardware Manual
Quick Maintenance
© 2021 QSAN Technology, Inc. All rights reserved.
www.qsan.com
Official
Document
69
▪
Remove the dummy host card cage by loosening two screws of the dummy host card cage
and then take dummy host card cage from controller module.
▪
Align the host card to the slot to be installed and use two screws that losing from dummy
host card cage to fasten on the controller.
▪
Repeat procedures above if there are other host adapter cards need to be installed.
▪
You must install GBIC (s) for the Fibre Channel or Ethernet host cards before connecting the
cables from the storage system to the host sides.
▪
Install the controller module into the system chassis if the host card installation completed.
Figure 4-27 Procedures of Removing the Host Card Dummy Cage