Installing the System Hardware
55
4.
Fourth step of the slide rails installation
。
Pull the middle member fully extended in locked position.
。
Ensure ball bearing retainer is located at the front of the middle member.
。
Insert chassis into middle-outer member.
。
When hitting the stop, pull/push release tab to unlock and retract chassis into rack.
。
Use M5x20 screws to fasten the chassis ear.
10
INFORMATION:
10
If you purchase optional slide rails, M5x20 screws that are dedicated for
optional slide rails are packed in the screws pack.
Figure 3-26
Fourth Step of the Slide Sails Installation
3.7.
Installing the Trays into the System
Before installing, please check if the carrier handle is at the open position. The following
procedure is for installing a tray into both LFF and SFF systems.
The following content and images are detailed steps for installing a tray into the system.
Align a disk drive with the tray to the empty bay you would like to install and then push it
all the way into the disk drive bay until the carrier handle is at closed position.
Lock the release button lock by pushing the lock from right to left.
