7
8
1. Mono analog input – accepts microphone or line level signals (with phantom power)
2. Stereo analog inputs – accepts line level signals
3. Analog audio inputs – connect to D-Cinema server or film processor with analog outputs
•
Top connector: channels 1 through 8
•
Bottom connector: 6 auxiliary channels
4. Digital audio inputs – connect to D-Cinema server or film processor with digital outputs
•
Top connector: AES3 pairs 1 through 4 (digital audio channels 1 through 8)
•
Bottom connector: AES3 pairs 5 through 8 (digital audio channels 9 through 16)
5. S/PDIF input – multi-channel digital input for non-sync/alternative content
6. USB Type B port for DCP configuration and management via direct connection
7. 10/100 Mbps Ethernet port – for QSControl™, 3rd party, or SNMP management and remote access
8. 100 Mbps Ethernet ports – CobraNet
™
audio network - Primary and Secondary (backup)
9. SD memory card – device configuration storage supports quick unit replacement
10. Serial communications port – 3
rd
party control/automation via RS232
11. IEC inlet – AC mains power connector with cord lock
12. DataPort interface for QSC amplifiers – supports up to six single port amplifiers
13. Hearing impaired and visually impaired special mix outputs
14. CMOS compatible logic outputs – for use as automation triggers, alerts, system status
15. Automation inputs – digitally sampled analog control inputs (control presets, levels etc.)
16. Relay outputs – mechanically decoupled control outputs (curtain, lighting control etc.)
17. Audio monitor output – tap from front panel monitor speaker (post DSP, pre amplifier)
DCP 200 Rear Panel Features
1
2
9
10
11
5
6
7
8
17
16
15
13 14
12
3
4
