19
TD-000487-00
K Series Service Manual
Rubber feet removal and installation notes
•
Rubber feet are secured to the enclosure with machine screws (on the exterior of the enclosure) and nuts (on the interi-
or of the enclosure).
•
Access to the interior of the speaker assembly is required to remove and install the rubber feet.
•
The easiest way to access the interior of the enclosure is to remove the BOP. See removal instructions in “5.1 Bucket of
power” on page 15.
•
Reapply a small amount of thread locking fluid to the nuts when replacing the rubber feet.
Pole cup removal and installation notes
•
Replace the entire pole-cup assembly if any parts are broken or have failed.
Individual parts are not available.
•
The pole cup assembly is secured to the enclosure with machine screws (on
the exterior of the enclosure) and mounting nuts (on the interior of the enclo-
sure).
•
Access to the interior of the speaker assembly is required to remove and install
the pole cup assembly.
•
Due to the limited space inside the enclosure, the baffle assembly and BOP
must be removed from the main enclosure to replace the pole-cup assembly.
•
Reapply a small amount of thread locking fluid to the nuts when replacing the
pole-cup assembly.
Figure 5.8 - To remove the rubber feet,
there must be access to the interior of the
enclosure
Figure 5.9 - To remove the pole cup
assembly, you must locate the nuts on the
interior of the enclosure
Summary of Contents for K8
Page 2: ...2 QSC Audio Products LLC...
