FEATURES & SETUP-
SIDE PANEL:
CROSSOVER & DELAY NETWORK SELECTION & INSTALLATION
The SIPs may be installed “either way”. The
SIPs are symmetrical and thus perform
identically no matter which end points to the
left or right. This completely eliminates
“polarity” errors that might otherwise arise.
The side cover plate must be removed to access
the SIP sockets. Be sure to reinstall the side
cover plate after installing the SIPs.
Before installing the SIP (as shown right) ensure
that the pins are straight. This will ease
insertion into the jack and help to avoid
damaging the pins due to misaligned insertion.
NOTE:
Reinstall the side
cover plate after SIP
installation to keep dust, dirt,
and foreign objects from
entering the internal
circuitry of the amplifier.
Failure to do so could result
in damage to the amplifier
should any such material
enter the chassis.
17
Turn the power to the amplifier off before removing or installing SIPs!
