24
SPECIFICATIONS- PowerLight 6.0 II Electrical Data
Note: Specifications are subject to change without notice.
Output Circuit Type
quasi-complementary MOSFET output with multi-step high efficiency circuit
Output Power in watts
20 Hz to 20 kHz
8 ohms per channel
1150 at 0.1% THD
4 ohms per channel
2050 at 0.1% THD
2 ohms per channel
3250 at 0.1% THD
EIA: 1 kHz @ 1% THD
8 ohms per channel
1300
4 ohms per channel
2200
2 ohms per channel
3500
Bridged Mode
16 ohms, 1 kHz, 1% THD
2600
8 ohms, 1 kHz, 1% THD
4400
4 ohms, 1 kHz, 1% THD
7000
Dynamic Headroom at 4 ohms
0.77 dB
Distortion, THD
20 Hz to 20 kHz
<0.06%: 8, 4, and 2 ohms at 10 dB below rated power
20 Hz to 2 kHz
<0.02%: 1150 watts at 8 ohms, 2050 watts at 4 ohms, 3250 watts at 2 ohm
Frequency response
at 10 dB below rated power
20 Hz to 20 kHz ±0.15 dB
2 Hz to 50 kHz ±3.0 dB
Damping Factor
>2000 at 1 kHz and below
Noise (unweighted)
107 dB below rated output from 20 Hz to 20 kHz
Voltage Gain
40x (32 dB)
Input Sensitivity
2.4 Vrms (+9.4 dBu) for rated power into 8 ohms
2.3 Vrms (+9.5 dBu) for rated power into 4 ohms
Input Impedance
20 k ohm balanced, 10 k ohm unbalanced
Controls
AC power switch, Mode switch, Gain controls, Clip Limiter switches
Connectors
Inputs: “combo” and terminal-block
Outputs:
binding posts, 60 amp rated, recommend no banana plug usage
Speakon outputs, 1 per channel for Stereo and Parallel operation only
Power Supply Control connector: 2-pin terminal block connector
LED Indicators
Power supply section:
Power “on”- red; Standby- yellow; Protect, red (1 LED for each channel)
Signal indicator section:
Signal- green; -20 dB, yellow; -10 dB, yellow; Clip, red (1 for each channel)
