v1.0
4 / 10
Installation Requirements
Tools Preparation
Screwdriver
Static-proof wristband
Bolt
Ethernet cable
Other Ethernet terminal devices
Control terminal
Safety Principles
The safety notices mentioned here means that improper operation may lead to body damage.
Read the installation guide carefully before you operate the system.
Only professionals are allowed to install or replace the switch.
Pull out the AC power socket before operating on the machine box or working beside the power source.
The final configuration of products must comply with relative national laws and regulations.
Site Environment
Make sure that the workshop is well-ventilated, the heat of electrical devices is well-discharged and sufficient air circulation is
provided for device cooling.
Avoid to damage devices by following the electrostatic discharge prevention procedure.
Put the machine box at the place where cool air can blow off the heat inside the machine box. Make sure the machine box is
sealed because the opened machine box will reverse the cool air flow.
Mounting the Switch
Connecting the Power
1. Plug the AC power cord to the switch power port on the back rear.
2. Connect the other end of the power cord to a AC power source equipment.
