01/2012
QS-HD
7
QS-HD
10 Technical data
Cutting type
Strip cut
Cross cut
Shred size (
mm)
5.8
3.9 x 30
1.9 x 15
Sa fe ty ra ting
German DIN 32757 – 1
2
3
4
Cutting ca pa ci ty
* (Sheet), DIN A4 70 g/m
2
80 g/m
2
28 - 30
22 - 24
15 - 18
12 - 14
10 - 12
8 - 10
Weight
26 kg
30 kg
Noise level
(Idle running/ load)
60 dB(A) / 64 dB(A)
62 dB(A) / 64 - 70 dB(A)
Cutting speed
120 mm/s
130 mm/s
Lo ading width
225 mm
Voltage
230 V, 50 Hz
100 V, 50/60 Hz – 115 V, 60 Hz
Power
for the maximum number of sheets
670 W
Operating mode
Continuous operation
Ambient conditions in operation:
Temperature
Relative humidity
Height above sea-level (MSL)
-10 °C to +40 °C
max. 90 %, without condensation
max. 2,000 m
Dimensions
W x D x H (mm)
448 x 347 x 828
Volume of shredded material bag
76 l
Applied standards and technical speci
fi
cations:
• EN 55014-1:2006
• EN 61000-4-2:1995 + A1:1998 + A2:2001
• EN 55014-2:1997 + A1:2001 + A2:2008
• EN 61000-4-4:2004
• EN 61000-3-2:2006
• EN 61000-4-5:2006
• EN 61000-3-3:1995 + A1:2001 + A2:2005
• EN 61000-4-6:2007
• EN 13849-1:2008
• EN 61000-4-11:2004
• EN 62233:2008
EC Declaration of Conformity
The manufacturer
HSM GmbH + Co. KG
, Austraße 1-9, 88699 Frickingen / Germany hereby declares that the ma-
chine, referred to here as
document shredder
QShred QS-HD
corresponds to the health and safety requirements of the following EC directives listed below due to its conception and
design of the version in which it was put into circulation by us:
Low voltage directive 2006 / 95 / EEC
EMC directive 2004 / 108 / EC
Frickingen, 01.03.2010
Rolf
Gasteier
-
Technical
Director
* The maximum number of sheets (DIN A4, 70 g/m² or 80 g/m²), fed lengthways, which can be cut in one cycle. The
performance data is determined when the motor is cold and the cutting device is freshly oiled. A weaker mains voltage
or a different mains frequency to the one speci
fi
ed could result in less sheet capacity and increased noise during op-
eration. The sheet capacity can vary depending on the structure and properties of the paper and on the way it enters.
The performance data in 80 g/m² is calculated.
