Beyond Navigation
2
7777
8888
9999
Appearance
1.
Power LED
2.
Memory LED
3.
Working LED
4.
Non-working LED
5.
Power button
6.
POI button
7.
USB connector
8.
Hard reset button
9.
Lanyard hole
LED Indications
LED symbol
LED Color
Status
Description
Power
Red
Flashing
Low Power
Green
On
Recharging under power off
Off
N/A
Fully charged
Memory
Orange
Flash 3 times
POI pressed , POI(Point of Interest) is
recorded
Orange
Flash per 2 sec.
Low memory (less than 20% left)
Orange
On
Memory is full
Off
N/A
1.
Memory has adequate capacity
2.
Device power off
Working
Green
On
GPS position is fixed, device is logging
Off
N/A
1.
GPS position not fixed
2.
Device enter sleeping mode(*)
3.
Memory is full
4.
Device power off
Non-working
Red
On
1.
GPS is not connected with satellite
2.
Memory is full
Red
Flash per 5 sec
Device enter sleeping mode(*)
Off
N/A
1.
GPS position is fixed
2.
Device power off
(*)Vibration sensor is set Off as default. Sleeping mode is functioned only when Vibration sensor is activated On by software.
Charge Battery
Fully charge the battery for 3 hours when using at the first time
For the first time using the CR-Q1100P, please charge battery until it is fully charged.
Please connect the supplied USB cable with your CR-Q1100P, and connect with any device has USB port, such as PC, Notebook
to recharge CR-Q1100P. A fully charged battery can last for 40 hours under optimal condition.
Start to Use
CR-Q1100P Operation
1.
Press and hold Power button for two seconds to power on CR-Q1100P, the buzzer will make 1 beep sound each time you
power on CR-Q1100P.
2.
The Non-working LED will be ON (Red) and waiting for device to acquire satellite signals.
CR-Q1100P is for outdoor use,
we strongly recommend using it outdoor under open sky environment for better satellite reception
.
3.
After getting GPS fix, the Non-Working LED will be Off and Working LED will be ON (Green). Then the device will start
functioning to record travel path automatically.
1111
2222
3333
4444
5555
6666
