13
QLK MOUNTING
Ignition connection
Connect the
white wire
to an ignition activated 12V
source through a 10-amp fuse (or SAE approved
equivalent).
Main power connection
a.
Disconnect the main power source.
b.
Determine the location for the Main Power Wires
and most protective routing methods for the
electrical wires so to prevent pinch points, wire
chafing, and sharp edges.
c.
Connect the red wire from a constant 12V source
( preferably vehicle battery) to PIN 5 (BATT + 12
VDC) of the Control Module.
d.
Connect black wire from chassis ground to PIN 6
(GND) of the Control Module.
Key Fob Pairing (Audible Version)
a.
Hold “KEY FOB” button on the Control Module for
5 seconds until the light on the Control Module
flashes red.
b.
Press the button on the key fob. The light on the
Control Module will now be green for 5 seconds,
showing that the key fob is paired.
13.
12.
11.