QTECH(config)dtag insert vlan1 vlan2 vlan3
3.3.4
dtag pass-through
Use this command to configure transparent transmission of dynamic QinQ.
dtag pass-through
[start vlan of the series vlan ] [end vlan of the series vlan]
no dtag pass-through
[start vlan of the series vlan ] [end vlan of the series vlan]
【
Parameter
】
start vlan of the series vlan: dynamic QinQ enabling, the tag packet which can be
transparent transmission without adding new tag head. The vlan is all vlans
between the start vlan.
【
Command configuration mode
】
Global configuration mode
【
Example
】
Configure all vlans to be transparent transmission from vlan1 to vlan2
QTECH(config)dtag pass-through vlan1 vlan2
3-16
Summary of Contents for QSW-2900
