【
Command configuration mode
】
Global configuration mode
【
Parameter
】
seconds
:
Range from 1 to 100 seconds. The default time is 10 seconds
【
Usage
】
This command is effective when fast leave disables
【
Example
】
!
Configure the max-response-time of igmp-snooping is 99 seconds
QTECH(config)#igmp-snooping max-response-time 99
4.2.5
igmp-snooping fast-leave
Use igmp-snooping fast-leave command to configure fast-leave of the interface.
When fast-leave enables, if the fast-leave message is received, the interface
leaves the aging group, or the time to leave is determined by the
max-response-time.
igmp-snooping fast-leave
no igmp-snooping fast-leave
4-10
Summary of Contents for QSW-2900
