Configure IGMP query source IP to demonstrate the destination IP to response to.
It is defaulted to be 0.0.0.0
igmp-snooping general-query source-ip
ipaddress
no igmp-snooping general-query source-ip
ipaddress
【
Command configuration mode
】
Any configuration mode
【
Parameter
】
ipaddress
:ip address of ipv4
【
Example
】
!Configure IGMP query source IP to be 1.1.1.111
QTECH(config)# igmp-snooping general-query source-ip 1.1.1.111
4.2.17
igmp-snooping query-max-respon
seconds
Configure the max response after receiving query, that is the response value in
IGMP query. It is defaulted to be 10s.
4-21
Summary of Contents for QSW-2900
