time-range-name:the name of time range with initial English letters (that is
[a-z,A-Z]) with any kind which is in the range of 1 to 32 characters.
【
Command configuration mode
】
Any configuration mode
【
Usage
】
show time-range command is used to display the configuration and status of
current time period. The time range which is activated will be displayed as active,
and the one which is inactivated will be displayed as inactive.
Caution: Because there is a time error when updating access-list status for
about 1 minute, and show time-range will judge it through current time, the fact
that show time-range saw a time range has been activated, but its access-list hasn’t
is normal.
【
Example
】
!Display all time range
QTECH(config-timerange-tm2)#show time-range all
!Display time range with the name of tm1
5-74
Summary of Contents for QSW-2900
