!Display port-isolation information
QTECH(config)#show port-isolation
6.1.7
storm-control
Use storm-control command to configure broadcast/known multicast/unknown
unicast/unknown multicast storm-control. Use show interface command to display
storm-control information.
storm-control rate
target-rate
storm-control
{ broadcast | multicast | dlf }
no storm-control
{ broadcast | multicast | dlf }
【
Parameter
】
broadcast:Configure broadcast storm-control
multicast:Configure known multicast storm-control
dlf:Configure unknown multicast storm-control
target-rate:The target rate of storm-control with the unit of Kbps
【
Command configuration mode
】
6-8
Summary of Contents for QSW-2900
