QTECH(config)#spanning-tree
!Disable STP on Ethernet 0/8
QTECH(config-if-ethernet-0/8)#no spanning-tree
7.1.3
spanning-tree cost
Use spanning-tree cost command to configure the path cost of the current port in
a specified spanning tree. Use no spanning-tree cost command to restore to the
default path cost of the current port in the specified spanning tree.
spanning-tree cost cost
no spanning-tree cost
【
Parameter
】
cost:Path cost to be configured for the port. This keyword ranges from 1 to 65535
【
Default
】
In IEEE 802.1D protocol, the default cost is determined by the speed of the port.
The port with the speed 10M have the cost of 100,100M, 19.
【
Command configuration mode
】
7-4
Summary of Contents for QSW-2900
