Use spanning-tree hello-time coammand to configure the hello time of the switch.
Use no spanning-tree hello-time command to restore to the default hello time.
spanning-tree hello-time seconds
no spanning-tree hello-time
【
Parameter
】
seconds:Hello Time in seconds to be configured. This keyword ranges from 1 to
10 seconds.
【
Default
】
The default hello time is 2 seconds
【
Command configuration mode
】
Global configuration mode
【
Usage
】
The system periodically sents STP messages. The period of a root bridge
sending STP messages is the hello time. Hello time is suggested to use 2
seconds.
7-7
Summary of Contents for QSW-2900
