【
Parameter
】
auto:Network bridge auto-detect whether or not the link connected to the current
Ethernet port is a point-to-point link.
forcefalse:Specifies that the link connected to the current Ethernet port is not a
point-to-point link.
forcetrue: Specifies that the link connected to the current Ethernet port is a
point-to-point link.
【
Default
】
Auto
【
Command configuration mode
】
Interface configuration mode
【
Example
】
!Configure the link connected to Ethernet 0/7 as a point-to-point link
QTECH(config-if-ethernet-0/7)#spanning-tree point-to-point forcetrue
7-12
Summary of Contents for QSW-2900
