!Enable spanning-tree remote-loop-detect interface of Ethernet 0/1, and ethernet
0/3
QTECH(config)#spanning-tree remote-loop-detect interface ethernet 0/1 ethernet
0/3
!Disable remote-loop-detect of Ethernet 0/1
QTECH(config-if-ethernet-0/1)#no spanning-tree remote-loop-detect
7.1.15
clear spanning-tree
Use clear spanning-tree command to clear STP information
clear spanning-tree
clear spanning-tree interface interface-list
【
Parameter
】
interface-list:List of Ethernet ports to be added to or removed from a VLAN. This
keyword needed to be provided in the form of interface-type + interface-number.
Interface-type is Ethernet and interface-number is slot-num/port-num, in which
slot-num is in the range of 0 to 2, and port-num is in the range of 1 to 24.
Seriate(sequential?) interfaces with the same type can be linked by to keyword,
7-18
Summary of Contents for QSW-2900
