send daemon is 60seconds.
【
Command configuration mode
】
Interface configuration mode, global configuration mode
【
Usage
】
This command is effective after 802.1x enables.
After 802.1x enables, configure according to the real situation.
【
Example
】
!Enable dot1x daemon on ethernet 0/5 with the period time of 20 seconds
QTECH(config-if-ethernet-0/5)#dot1x daemon time 20
!Configure dot1x daemon of ethernet 0/5 globally with the period time of 20
seconds
QTECH(config)#dot1x daemon time 20 interface ethernet 0/5
!Restore the default dot1x daemon configuration on ethernet 0/5
QTECH(config-if-fastethernet-5)#no dot1x daemon
8-25
Summary of Contents for QSW-2900
