【
Command configuration mode
】
Global configuration mode
【
Usage
】
This command should be effective by sending message through multicast
address in anycast operation mode. In order to restrict the range of sending
multicast message, TTL-value setting is suggested.
【Example】
!Configure TTTL-value of sending multicast message to be 5
QTECH(config)#sntp client multicast ttl 5
9.1.8
sntp client poll-interval
Use sntp client poll-interval command to configure poll-interval of SNTP client in
unicast or anycas. Use no sntp client poll-interval command to restore default
poll-interval.
sntp client poll-interval seconds
no sntp client poll-interval
9-9
Summary of Contents for QSW-2900
