anycast operation mode. Use no sntp client retransmit command to configure
SNTP client not to retransmit requirement message.
sntp client retransmit times
no sntp client retransmit
【
Parameter
】
times:Times of retransmit ranges from 1 to 10
【
Default
】
non-retransmit(0)
【
Command configuration mode
】
Global configuration mode
【
Usage
】
In order to guarantee reliable transmission of SNTP client, overtime
retransmission system is adopted. The requirement message will be resent if
there’s no reply in a certain time until the retransmit times limits. This command is
effective in unicast and anycast operation mode, because these modes need
9-11
Summary of Contents for QSW-2900
