level:Level of information ranges from 0 to 7
xxx:Means the name of the module. … means other modules are omitted.
【
Command configuration mode
】
Any configuration mode
【
Usage
】
Use keyword “level-list” to display the specified level information in list. If the
“level-list” is not specified, the information of the higher level (The smaller the
level number is, the higher the level is.) and the equal level will be displayed.
【
Example
】
!Display the flash log of module vlan
QTECH(config)#show logging flash module vlan
10.1.4
show logging filter
Use show logging filter command to display filter log.
show logging filter
{ monitor monitor-no | buffered | flash | host ip-address |
snmp-agent }
10-4
Summary of Contents for QSW-2900
