filter configuration. Use no logging snmp-agent command to disable SNMP Agent
logging and restore to default filter configuration.
logging snmp-agent
no logging snmp-agent
logging snmp-agent
{ level |
none
|
level-list
{ level [
to
level ] } &<1-8> }
[
module
{
xxx
|
…
} * ]
no logging snmp-agent filter
【
Parameter
】
level:Level of information ranges from 0 to 7
none:Any level is not allowed.
xxx:Means the name of the module. … means other modules are omitted.
【
Default
】
All SNMP Agent logging enable.
Filter regulations of all terminals are to allow all modules of levels 0 to 5 to output
information
【
Command configuration mode
】
10-22
Summary of Contents for QSW-2900
