Use load configuration ftp command to load configuration program by FTP
protocol.
load configuration ftp
ftpserver-ip filename username userpassword
【
Parameter
】
ftpserver-ip:IP address of FTP server
filename:Filename to be loaded
username、userpassword:Username and password of FTP server
【
Command configuration mode
】
Privileged mode
【
Usage
】
Open FTP server and set username, password and file download path before use
this command. Reboot the switch after successful download and run new
configuration program.
【
Example
】
12-11
Summary of Contents for QSW-2900
