Use bootp command to enable bootp way to obtaining ip address. Use no bootp
command to disable bootp.
bootp
no bootp
【
Default
】
BOOTP disables
【
Usage
】
The way to obtain IP address are by BOOTP、DHCP、and manual operation. If
BOOTP enables, the switch will obtainn the ip address by bootp, and DHCP or
manual operation will be error. If DHCP is wanted, input no bootp first,then input
dhcp。
【
Command configuration mode
】
Global configuration mode
【
Example
】
!Enable BOOTP to obtainn IP address
12-26
Summary of Contents for QSW-2900
