【
Example
】
!Display vct auto-run.
QTECH(config)#show vct auto-run
12.4.11
mac-address-table
Use mac-address-table command to add mac address table. Use no
mac-address-table command to remove mac address table.
mac-address-table
{ dynamic | permanent | static } mac
interface
interface-num
vlan
vlan-id
mac-address-table blackhole mac vlan vlan-id
no mac-address-table
[ blackhole | dynamic | permanent | static ]
mac
vlan
vlan-id
no mac-address-table
[ dynamic | permanent | static ] mac
interface
interface-num
vlan
vlan-id
no mac-address-table
[ dynamic | permanent | static ]
interface
interface-num
no mac-address-table
[ blackhole | dynamic | permanent | static ]
vlan
vlan-id
no mac-address-table
【
Parameter
】
mac:Unicast mac address
vlan-id:VLAN id
12-36
Summary of Contents for QSW-2900
