!Configure MAC address aging time to be 600 seconds
QTECH(config)#mac-address-table age-time 600
12.4.13
mac-address-table learning
Use mac-address-table learning command to enable MAC address learning. Use
no mac-address-table learning command to disable MAC address learning. When
disabling, the message from a port whose source address is not in this port, will not
be transmitted.
mac-address-table learning
no mac-address-table learning
【
Command configuration mode
】
Global configuration mode
【
Example
】
!Enable MAC address learning.
QTECH(config)#mac-address-table learning
12.4.14
mac-address-table learning mode
12-39
Summary of Contents for QSW-2900
