100 BASE-FX only supports full duplex.
【
Example
】
!Configure ethernet 0/5 port to full duplex
QTECH(config-if-ethernet-0/0/5)#duplex full
2.1.4
flow-control
Use flow-control command to enable flow control on the Ethernet port. Use no
flow-control command to disable flow control on the port.
flow-control
no flow-control
【
Default
】
Disable
【
Command configuration mode
】
Interface configuration mode
【
Usage
】
2-6
Summary of Contents for QSW-2900
