!Configure LLDP hello-time to be 20 seconds
QTECH(config)#lldp hello-time
20
13.1.3
lldp hold-time
Use lldp hold-time command to configure LLDP hold-time. Use no lldp hold-time
command to restore LLDP hold-time.
lldp hold-time <2-10>
no lldp hold-time
【
Default
】
Default LLDP hold-time is 4
【
Command configuration mode
】
Global configuration mode
【
Example
】
!Configure LLDP hold-time to be 2
QTECH(config)#lldp hold-time
2
13.1.4
lldp { rx | tx | rxtx }
13-88
Summary of Contents for QSW-2900
