Use lldp command to configure LLDP message receving and sending mode. Use
no lldp command to disable LLDP message receving and sending mode.
lldp { rx | tx | rxtx }
no lldp
【
Default
】
The default LLDP message receving and sending mode to be rxtx
【
Command configuration mode
】
Interface configuration mode
【
Example
】
!Configure e 0/1 only to send LLDP message
QTECH(config-if-ethernet-0/1)#lldp tx
13.1.5
show lldp interface [
<interface-list>
]
Use show lldp interface command to display LLDP information globally or on a port.
show lldp interface
[ <interface-list> ]
【
Command configuration mode
】
13-89
Summary of Contents for QSW-2900
