Use priority command to assign priority of the port. Use no priority command to
restore default priority.
priority
priority-value
no priority
【
Parameter
】
priority-value:Ranges from 0 to 7
【
Default
】
Default priority-value is 0
【
Command configuration mode
】
Interface configuration mode
【
Usage
】
The larger priority-value is, the higher the priority is.
【
Example
】
!Configure priority-value of Ethernet 0/0/3 to be 1
2-10
Summary of Contents for QSW-2900
