【
Command configuration mode
】
Interface configuration mode
【
Usage
】
Use no shutdown command to enable an Ethernet port after related parameter
and protocol are configured. Disable a port and then enable it when there is a
failure, which can recover the port.
【
Example
】
!Disable Ethernet 0/0/1, then enable it.
QTECH(config-if-ethernet-0/0/1)#shutdown
QTECH(config-if-ethernet-0/0/1)#no shutdown
2.1.12
speed
Use speed command to configure the port speed. Use no speed command to
restore the port speed to the defaulting setting.
speed
{ 10 | 10auto | 100 | 100auto | auto }
no speed
2-15
Summary of Contents for QSW-2900
