of half, full duplex and auto-negotiation mode. 100 BASE FX supports the speed
of 100Mbps and the duplex mode of full duplex.
【
Example
】
!Configure the speed of Ethernet 0/0/1 to 100Mbps
QTECH(config-if-ethernet-0/0/1)#speed 100
2.1.13
bandwidth-control
Use bandwidth-control command to control the egress and ingress bandwidth
and limit the total rate of receiving and sending messages. Use no
bandwidth-control command to cancel ingress and egress bandwidth-control
configuration.
bandwidth-control { ingress | egress }
target-rate
no
bandwidth-control { ingress | egress }
【
Parameter
】
target-rate:The total rate of bandwidth-control ranges from 64 to 1024000 Kbps
【
Command configuration mode
】
2-17
Summary of Contents for QSW-2900
