【
Example
】
QTECH(config)#show bandwidth-control
2.1.15
switchport access
Use switchport access command to add current port to specified VLAN, and the
default VLAN-ID is configured to be the specified VLAN.
Use no switchport access command to remove current port from specified VLAN,
except VLAN 1, and if the default vlan-id of the current port is the specified VLAN
and this port also belongs to VLAN 1, the default vlan-id of the current port
restores to be 1.
switchport access vlan vlan-id
no switchport access vlan vlan-id
【
Parameter
】
vlan-id:ID of a VLAN ranges from 2 to 4094
【
Command configuration mode
】
Interface configuration mode
2-19
Summary of Contents for QSW-2900
