Use no mirror destination-interface command to remove mirror interface.
mirror destination-interface interface-num
no mirror destination-interface interface-num
【
Parameter
】
interface-num:Means Ethernet port. Interface-num is in the form of interface-type
+ interface-number. Interface-type is Ethernet and interface-number is
slot-num/port-num, in which slot-num is in the range of 0 to 2, and port-num is in
the range of 1 to 24.
【
Command configuration mode
】
Global configuration mode
【
Example
】
!Configure Ethernet 0/0/1 to be mirror destination-interface
QTECH(config)#mirror destination-interface ethernet 0/0/1
2.2.2
mirror source-interface
Use mirror source-interface command to configure mirror source-interface. Use
2-28
Summary of Contents for QSW-2900
