vlan
vlan-list
no vlan
{ vlan-list | all }
【
Parameter
】
vlan-list:The VLAN which you want to create and whose view you want to enter.
Each id ranges from 1 to 4094.
all:Specifying all when removing VLAN, all created VLANs are removed except
the default VLAN.
【
Command configuration mode
】
Global configuration mode
【
Usage
】
Use the vlan command to enter VLAN configuration view. If the vlan identified by
the vlan-id keyword exists, enter VLAN configuration view. If not, this command
creates the VLAN and then enters VLAN configuration view. Use the no vlan
command to remove a VLAN. Caution: Default VLAN (VLAN 1) cannot be
removed. If there is some port with the same default vlan-id as VLAN 1, the port’s
3-6
Summary of Contents for QSW-2900
