QTECH(config)dtag outer-tpid 9100
3.3.2
dtag mode
Use dtag mode command to configure interface QinQ mode.
dtag mode
{ customer | uplink
}
no dtag mode
【
Parameter
】
customer: In this mode, the original tag head will be ignored and a new one will
be added.
uplink: In this mode, when the vlan protocol number of ingress packet is different
from the configured parameter of the interface and not the default value 8100, a
new tag head will be added.
【
Command configuration mode
】
Interface configuration mode
【
Example
】
Configure interface to be customer interface.
3-14
Summary of Contents for QSW-2900
