AN-X3-GENI Page
13
Quick Start
Step
See page
1
Power up the AN-X, connect it to Ethernet and assign it an IP
address
13
2
(Not needed for existing installations) Use the Genius handheld
monitor to assign serial bus addresses to Genius devices and
perform any other necessary configuration.
3
Use the AN-X web interface to set the baud rate and serial bus
address for the AN-X3-GENI
21
4
Connect AN-X to the Genius network
11
5
Use the AN-X web interface to autoconfigure the Genius
network and ControlLogix configuration
22
6
Configure the AN-X in RSLogix 5000
35
7
Use the web interface to obtain aliases for RSLogix 5000
37
8
Import the aliases into RSLogix 5000
38
9
Use the aliases to access data
