User Manual – QTFX-V1
160.456UK
10
13. Wireless Remote Control:
Press the ON button to turn on the continuous out put from the smoke machine
and the OFF button to stop all output.
If the remote is not working then you may need to pair the wireless controller
with the smoke machine.
Ensure the wireless remote mode is turned on (see next section) Turn on the
machine and the LCD display will show as below.
During this time press and hold any button on the wireless controller until the
display flashes twice to indicate a match. (Note this can take up to 12 seconds)
Once this has been done the wireless remote frequency will be stored and there
will be no need to do this again.
User Manual – QTFX-V1
160.456UK
7
9. Replacing Fuse :
Disconnect from the main power supply first, then remove the fuse holder
above the IEC Socket to reveal the fuse. Replace the correct fuse rating as
stated on lighting or user guide. Then, lock the fuse holder cover back into
place.
10. General Maintenance :
To maintain optimum performance and minimize wear, the item should be
cleaned frequently. Usage and environment are contributing factors in
determining frequency. As a general rule, fixtures should be cleaned after
use to avoid dust build-up and blockages, which can result in poor
performances, overheating and breakages. Be sure to power off the
fixture before conducting maintenance.
Unplug fixture from power. Use a vacuum or air compressor and a soft
brush to remove dust collected on external vents and internal components.
Clean the external case when the fixture is cold with a dry cloth or tissue,
and drag dirt and grime to the outside case.
To ensure a continuing high performance it is recommended to use water
or smoke cleaning fluid (160.670) to clean the internal workings. Simply
empty the tank of any smoke fluid. Fill with water or smoke cleaning fluid
then operate two full cycles to clean the internal pipes this should be done
once every 2 months to ensure continuing high performance
