152.760UK User Manual
DMX
The fixture is equipped with 3-pin XLR connectors for DMX input and output. The SE
connectors are wired in parallel. Only use a shielded twisted-pair cable designed for 3-pin XLR-
plugs and connectors in order to connect the controller with the fixture or one fixture with
another.
Building a serial DMX-chain:
Caution:
At the last fixture, the DMX-cable has to end with a terminator. Solder a 120 Ohm
resistor between PIN 2 (-) and PIN 3 (+) into a 3-pin XLR-plug and plug it in the DMX-output
of the last fixture.
When in DMX mode there are two channels with the following function:
152.760UK User Manual
INTRODUCTION:
3D SPIRO 2.0 RGB LASER
Thank you for purchasing this 3D Spiro 2.0 laser.
This updated version of our ever-popular Spiro Laser has a range of exciting additional 3D
patterns. The high power 638nm red laser diode produces a much brighter beam with the
benefits of reduced laser radiation. The colour-changing beam and pattern effects are best
viewed when projected onto a flat surface, and adding smoke or haze will further enhance the
impressive effects making it ideal for mobile DJs and venue installation.
Unique 3D patterns
Brighter 638nm Red laser technology
0.45W total laser power (Red: 100mW, Green 50mW, Blue: 300mW)
Auto, sound-to-light, pattern select and 10 channel DMX modes
Master/slave mode
Easy digital display to set the mode of operation
Key controlled for laser safety
We recommend that this product is used within the guidelines HSG95
