160.458UK User Manual
SETUP:
1.
Unpack the FH-700 unit.
2.
Unscrew the top cap of the tank and remove to fill with the recommended
haze fluid.
3.
Replace the bottle and screw the cap securely ensuring the pipe is fed down to
the bottom of the bottle so a consistent flow of fluid is supplied to the
machine.
4.
Connect the remote control.
5.
Connect the IEC mains plug and power up.
6.
Heat up time is usually between 5-6 minutes. Please ensure no button is
pressed during the heat up time. When the machine is ready the LED light on
the remote control will illuminate.
7.
Turn the output to max and press the green button on the remote control for
5 seconds so the fluid has a chance to flow through the heater block making it
ready to use.
8.
After this adjust the fan speed on the unit and the output on the remote
control to find the level you desire. It is recommended to produce haze/fog
with small pauses in between so that the temperature is maintained and the
thermostat doesn’t switch off.
CAUTION! TO PREVENT MORTAL ELECTRICAL RISK AND LONG LIFE OPERATION:
For your safety, please kindly pay attention to all of the warnings listed below:
Always plug in the power plug last and disconnect from the mains when the
device is not in use or before cleaning.
Do not install and operate the device in rain or extreme heat, moisture or dusty
environments.
This device is for indoor use only and in a dry environment.
Do not switch on immediately but wait until it reaches to room temperature if
the device has been exposed to drastic temperature fluctuations.
Do not shake the device and avoid brute force when installing or operating.
Do not use the device during thunderstorms and please disconnect the power.
Do not use solvents or aggressive detergent to clean the device. Use a soft and
clean cloth.
Do not modify the device or the connected power cord without authorisation.
