154.323UK User Manual
Onboard Menu
Display
Press Enter to set value
Press Enter again to confirm
Description
-
DMX start address
-
DMX channel mode
–
5 or 9 channels
-
-
Master/Slave/DMX mode (FAIL means no Master/Slave)
xxx
-
Manual colour red level 0-100%
xxx
-
Manual colour green level 0-100%
xxx
-
Manual colour blue level 0-100%
xxx
-
Manual colour white level 0-100%
xxx
-
Manual colour amber level 0-100%
xx
Enter to set
-
Sound activated colour change (
-
= mic sensitivity)
xx
Enter to set
-
Static colour (
-
= colour selection)
xx
Enter to set
-
Auto colour jump program (
-
= speed)
xx
Enter to set
-
Auto colour scroll program (
-
= speed)
-
Strobe (
= off,
-
= speed)
Standalone operation
To operate the HIPAR-100 in standalone (autonomous) mode, navigate to
and select Master mode.
Sound-activated, Static colour, Auto, Fade & Strobe modes described above will operate without DMX control.
To control further HIPAR cans in master-slave mode, connect the DMX through from a master HIPAR-100 in
standalone mode to the DMX input of a
“
slave
”
HIPAR can that is set to Slave mode under the
menu.
Further HIPAR cans set to Slave mode may be connected from DMX through to DMX input in a daisy chain.
If the strobe setting is
-
, a flashing strobe effect will be applied to the Auto program (slow to fast)
For custom static colours, adjusting the values of
xxx,
xxx,
xxx,
xxx and
xxx gives a manual colour mix.
DMX operation
The HIPAR-100 is compatible with standard DMX512 control.
Connect the supplied XLR plug to waterproof socket lead to the DMX input lead of the first HIPAR can in line
to be controlled. Connect further HIPAR cans from the DMX through of the first can to the DMX input of the
second can and DMX through of the second can to the DMX input of the third can etc. until all HIPAR cans are
connected in a daisy-chain.
Connect the XLR plug to a DMX controller, ensuring that this connection is protected from the elements.
(the XLR plug is not a waterproof connector)
The HIPAR-100 has either 5 or 9 DMX channels as described in the tables on the following pages. Set the DMX
value to the required start address via the control panel and this will become the DMX address of channel 1.
