PAL12 PAL15 User Manual
Bluetooth™ Connection
On the media player, s
elect ‘
’ using the
MODE
button.
Scan for Bluetooth devices on your smart phone or other Bluetooth enabled audio player and
check for a device called
‘
PAL SERIES
’
. Select this device and opt to connect your Bluetooth
device, which should then
state that it is connected to “
PAL SERIES
” for audio output
.
Play audio from your Bluetooth device and check for output through the PAL SERIES unit.
Ensure that the volume is turned up on the smart phone or other sending device.
If there is no output, check if there is more than one device with
in range called “
PAL SERIES
”
In the eventuality that more than
one device is called “
PAL SERIES
”, try
each device in turn
until the PAL SERIES is found. Check also that the volume level is turned up on the sending
device.
Once audio is playing through the PAL SERIES from Bluetooth, adjust the MEDIA VOL (15) and
MASTER volume (18) controls to the required volume.
In Bluetooth mode, the Play/Pause, Previous and Next buttons can also remotely control
playback from the sending device. Holding down the Previous or Next buttons will decrease or
increase the Bluetooth output volume.
Bluetooth on the PAL SERIES can only pair to a single device at any one time and should be
operable over a range of 5 to 8 metres.
Remote control
The media player controls are also available on the I.R. remote control handset and operate in
the same way as described above for the panel media player controls. The remote handset is
supplied with a clear plastic pull tab at the bottom, which must be removed to engage the
battery before operation.
1
Repeat function
2
Power on/standby
3
C/- for FM tuner
4
Previous / Next track buttons
5
Volume up / down buttons
6
Mode select button
7
EQ profile select button
8
Play / Pause button
9
Numerical track select buttons 0-9
